| Bob Holman Plans P.O. Box 741 San Bernardino CA 92404 909-885-3959 [email protected] www.bhplans.com |
|
|
My laser has a 48”x24” vacuum table to hold the material down. Many engraving lasers
cut on a metal table which will leave the bottom of the balsa parts brown. The table
leaves the bottom as clean as possible. We can cut full 36” or 48” balsa or plywood.
With the extra power we can cut up to 1/4” aircraft ply at .4 inches a second. We use
the splitter on balsa up to 1/8” thick to 48” in length.
cut on a metal table which will leave the bottom of the balsa parts brown. The table
leaves the bottom as clean as possible. We can cut full 36” or 48” balsa or plywood.
With the extra power we can cut up to 1/4” aircraft ply at .4 inches a second. We use
the splitter on balsa up to 1/8” thick to 48” in length.
| TIRED OF GIVING PLAQUES FOR CONTEST AWARDS WE HAVE THE PRACTICAL SOLUTION Mugs are available in a number of different sizes and are priced as low as $7.00 We can put use your club logo or any GOOD SHARP color photo We can also supply color sublimated plaques, coasters and mouse pads. |